summaryrefslogtreecommitdiffstats
path: root/roles/out
Commit message (Collapse)AuthorAgeFiles
* postfix: remove explicit default 'mail_owner = postfix'.Guilhem Moulin2018-12-061
|
* Postfix: replace cdb & btree tables with lmdb ones.Guilhem Moulin2018-12-031
| | | | Cf. lmdb_table(5).
* Perform recipient address verification on the MSA itself.Guilhem Moulin2018-04-041
|
* Use blackhole subdomain for sender addresses of verify probes.Guilhem Moulin2017-05-161
| | | | | | | | | | | These addresses need to be accepted on the MX:es, as recipients sometimes phone back during the SMTP session to check whether the sender exists. Since a time-dependent suffix is added to the local part (cf. http://www.postfix.org/postconf.5.html#address_verify_sender_ttl) it's not enough to drop incoming mails to ‘double-bounce@fripost.org’, and it's impractical to do the same for /^double-bounce.*@fripost\.org$/.
* postfix: Remove obsolete templates tls_policy/relay_clientcerts.Guilhem Moulin2016-07-121
|
* postfix: commit the master.cf symlinks.Guilhem Moulin2016-07-121
|
* Route all internal SMTP traffic through IPsec.Guilhem Moulin2016-07-102
|
* Postfix: don't share the master.cf between the instances.Guilhem Moulin2016-07-102
|
* postfix: Don't explicitly set inet_interfaces=all as it's the default.Guilhem Moulin2016-07-101
|
* Route SMTP traffic from the webmail through IPsec.Guilhem Moulin2016-07-101
|
* postfix: rotate the sender address for verify probes.Guilhem Moulin2016-06-021
| | | | | In order to avoid ‘double-bounce@’ ending up on spammer mailing lists. See http://www.postfix.org/ADDRESS_VERIFICATION_README.html .
* postfix: Update to recommended TLS settings.Guilhem Moulin2016-05-181
| | | | | | | | Following Viktor Dukhovni's 2015-08-06 recommendation http://article.gmane.org/gmane.mail.postfix.user/251935 (We're using stronger ciphers and protocols in our own infrastructure.)
* postfix: unset 'smtpd_tls_session_cache_database'.Guilhem Moulin2016-05-181
| | | | | | Following Viktor Dukhovni's 2015-08-06 recommendation for Postfix >= 2.11 http://article.gmane.org/gmane.mail.postfix.user/251935
* Move /etc/ssl/private/dhparams.pem to /etc/ssl/dhparams.pem and make it public.Guilhem Moulin2016-05-181
| | | | | | | | | | Ideally we we should also increase the Diffie-Hellman group size from 2048-bit to 3072-bit, as per ENISA 2014 report. https://www.enisa.europa.eu/publications/algorithms-key-size-and-parameters-report-2014 But we postpone that for now until we are reasonably certain that older client won't be left out.
* Remove SMTP message size limit on non public MTAs.Guilhem Moulin2016-03-211
|
* Postfix TLS policy: Store the fingerprint of the cert's pubkey, not of the ↵Guilhem Moulin2015-12-031
| | | | cert itself.
* Fix address verification probes on the MSA.Guilhem Moulin2015-09-161
| | | | | Put all relay restrictions under smtpd_relay_restrictions and leave smtpd_recipient_restrictions empty, since we don't do DNSBL.
* Use 'double-bounce@fripost.org' as envelope sender for verification probes.Guilhem Moulin2015-06-111
|
* Don't bounce unverified recipients upon 4xx errors.Guilhem Moulin2015-06-111
| | | | | | | We don't want to bounce messages for which the recipient(s)' MTA replies 451 due to some greylisting in place. We would like to accept 451 alone, but unfortunately it's not possible to bounce unverified recipients due to DNS or networking errors.
* Configure munin nodes & master.Guilhem Moulin2015-06-102
| | | | | Interhost communications are protected by stunnel4. The graphs are only visible on the master itself, and content is generated by Fast CGI.
* Use recipient address verification probes.Guilhem Moulin2015-06-071
| | | | | | | This is specially useful for mailing lists and the webmail, since it prevents our outgoing gateway from accepting mails known to be bouncing. However the downside is that it adds a delay of up to 6s after the RCPT TO command.
* logjam mitigation.Guilhem Moulin2015-06-071
|
* Upgrade Postfix config to Jessie (MSA & outgoing proxy).Guilhem Moulin2015-06-071
|
* Remove reject_unknown_sender_domain from the MDA and outgoing SMTP.Guilhem Moulin2015-06-071
| | | | | | | | | | We already removed it from the MX:es (see 32e605d4); we need to remove it from the MDA and outgoing SMTP as well, otherwise mails could bounce or get stuck in the middle (the're rejected with 450: deferred by default). However we can keep the restriction on the entry points (MSA and webmail).
* Replace Postgrey with postscreen.Guilhem Moulin2015-06-071
| | | | | | | | | | | See http://www.postfix.org/POSTSCREEN_README.html and http://rob0.nodns4.us/postscreen.html It's infortunate that smtpd(8) cannot be chrooted any longer, which means that we have to un-chroot cleanup(8) as well. Indeed, currently smtpd(8) uses $virtual_alias_maps for recipient validation; later cleanup(8) uses it again for rewriting. So these processes need to be both chrooted, or both not.
* Hash certs using a lookup in the template instead of add a new task.Guilhem Moulin2015-06-072
|
* Add a tag 'tls_policy' to facilitate rekeying.Guilhem Moulin2015-06-071
| | | | | First generate all certs (-t genkey), then build the TLS policy maps ( -t tls_policy).
* Tell vim the underlying filetype of templates for syntax highlighting.Guilhem Moulin2015-06-071
|
* Reload Postfix upon configuration change, but don't restart it.Guilhem Moulin2015-06-072
| | | | | | (Unless a new instance is created, or the master.cf change is modified.) Changing some variables, such as inet_protocols, require a full restart, but most of the time it's overkill.
* Don't restart/reload Postifx upon change of a file based database.Guilhem Moulin2015-06-071
| | | | | | And don't restart or reload either upon change of pcre: files that are used by smtpd(8), cleanup(8) or local(8), following the suggestion from http://www.postfix.org/DATABASE_README.html#detect .
* Install amavisd-new on the outgoing SMTP proxy.Guilhem Moulin2015-06-071
| | | | For DKIM signing and virus checking.
* Replace IPSec tunnels by app-level ephemeral TLS sessions.Guilhem Moulin2015-06-073
| | | | | For some reason giraff doesn't like IPSec. App-level TLS sessions are less efficient, but thanks to ansible it still scales well.
* Outgoing SMTP proxy.Guilhem Moulin2015-06-073